2231 Hex V2 Clone Repair New |link| | Vcds

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

If your VCDS 22.3.1 HEX-V2 clone cable recently stopped working, you are not alone. These diagnostic cables frequently face software corruption, firmware blocks, or hardware failures. vcds 2231 hex v2 clone repair new

An ST-Link V2 programmer (for STM32 chips) or a USBasp (for Atmega chips). This public link is valid for 7 days

Carefully open the plastic casing to expose the green printed circuit board (PCB). Can’t copy the link right now

or STM32CubeProgrammer : Official STMicroelectronics flashing software.

If your cable is stuck with flashing red lights (failed update mode), you can attempt to force a reflash:

If you see , "USB Serial Converter" , or a yellow exclamation mark, the FTDI chip has lost its configuration or the hardware is damaged. Run the VCDS Test Open your VCDS 22.3.1 software. Click on Options , select USB , and click Test .