AT : Illuminates continuously when the controller is executing its .
Activates the programmed schedule. Note: Ensure that if you want the schedule to start immediately, set the mode relative to your current time (e.g., if it's currently supposed to be off based on your timeline, cycle to OFF and then to AUTO). 5. Troubleshooting Common Issues The screen is entirely blank
Once your desired temperature is set, press the key once to save it. 4. Parameter Settings and Configuration
Always ensure the power is off before wiring to avoid electric shock or damage to the unit.
: Access parameter C10 . Use 'Da' for heating mode (power applies when PV < SV) and 'Re' for cooling mode (power applies when PV > SV). Autotuning : This feature allows the sinotimer mc101 manual
Set "AT" to 1. The AT light on the panel will blink until the cycle is complete and the controller has calculated its PID constants.
Navigating the interface requires understanding the function of the four primary buttons:
The manual includes clear schematics for terminal connections, which is vital for preventing short circuits during installation. Auto-Tuning Guide:
The light indicator on the front panel will begin flashing, indicating that auto-tuning is active. AT : Illuminates continuously when the controller is
Press the again to shift to the tens, hundreds, or thousands digit.
Your heater and cooling pathways may be reversed, or your sensor is placed too far from the heating element, causing massive thermal lag.
Sinotimer devices are built to resist dust and moisture, but they should still be housed in a proper enclosure for longevity in harsh environments. Temperature Controller - Sinotimer
: Test the controller on non-critical loads first to confirm your programming logic is correct before full operation. Parameter Settings and Configuration Always ensure the power
Auto-tuning enables the controller to learn the thermal characteristics of your system for maximum accuracy. Set your desired temperature (SV).
Connect to the Positive (+) DC input terminal of your SSR (usually Terminal 3 on the SSR).
: Hold the Clock button while pressing D+ (Day), H+ (Hour), and M+ (Minute) to set current time.