Brc1c51 61 Installation Manual | Daikin

Press the to confirm and save the new parameters.

Route the other end of the wire to the indoor unit electrical box. Connect them to the corresponding and P2 terminals on the indoor unit terminal block. Dual Remote Controller Setup (Main vs Sub)

On the back of one controller's circuit board, locate the slide switch labeled MAIN/SUB . Leave the primary controller set to MAIN . Flip the switch on the secondary controller to SUB . 4. Field Settings and Configuration

Run the opposite end of the cable to the indoor unit control PCB and connect them to the matching P1 and P2 terminals. Step 4: Reassemble the Controller daikin brc1c51 61 installation manual

Once powered, the controller will usually auto-detect the indoor unit, but you may need to configure settings:

Route the other end of the cable to the indoor unit's control PC board and connect it to the corresponding and P2 (Remote Controller) terminals. 5. Field Settings and Commissioning

Hook the top tabs of the upper case onto the top of the lower case. Press the to confirm and save the new parameters

This indicates a communication error between the remote controller and the indoor unit. Check the wire connections.

Configures the display to show the "Filter Clean" notification icon sooner for heavy-dust environments.

This guide covers the installation of the Daikin BRC1C51 (Wired) and BRC1C61 (Wireless) remote controllers. These are typically used with Daikin SkyAir and VRV systems. Dual Remote Controller Setup (Main vs Sub) On

: If controlling multiple units, the remote is connected to the first unit, and subsequent units are daisy-chained via their P1/P2 terminals. Initial Setup and Configuration

If you need help configuring specific , setting up a master/slave layout , or translating an error code you are seeing, please tell me:

Connect the wires to the and P2 terminals on the remote controller terminal block. Tighten the screws securely.