Baofeng Uv-10r: Programming Software

What specific (local repeaters, emergency, weather channels) are you planning to program?

Plug the USB end of the programming cable into your computer.

If you purchase an RT Systems kit, the required drivers are installed along with the software. Their cable is also guaranteed to work with Windows 11, and their support team can help troubleshoot any issues.

Cliff Linton That fixed it!!! Thank you very much :) Baofeng Uv-10r Programming Software

The UV-10R uses a but requires a specific Prolific or Silicon Labs chipset inside the USB cable.

: Often harder to find but available via the Baofeng download page .

The only guaranteed software is the official (often labeled BF-UV10R_Eng.exe or similar). Their cable is also guaranteed to work with

Remember, for the UV-10R, you must select BF-F8HP in CHIRP, not UV-10R, otherwise, the upload will fail. Conclusion

: Many cheap cables use "counterfeit" Prolific chips. Modern Windows updates often disable these drivers, resulting in a "Code 10" error in Device Manager.

This usually means the 2-pin cable is not pushed deep enough into the radio casing. Squeeze it tightly and try again. It can also mean you selected the wrong COM port or radio model. : Often harder to find but available via

Let’s say the repeater is with a -0.6 MHz offset and PL tone 100.0 Hz .

Follow these steps precisely to avoid connection errors or bricking your device. Step 1: Install the Hardware Drivers

Access hidden settings like the "Squelch Service Menu" to improve signal reception. Essential Hardware Requirements