Manual — Zoje A6000-g 02

Turn the screw counterclockwise to increase the oil flow volume. Turn the screw clockwise to decrease the oil flow volume.

This comprehensive technical guide serves as an operational blueprint, consolidating critical setup procedures, control panel configuration parameters, daily maintenance routines, and troubleshooting protocols extracted from the official factory engineering literature. Technical Specifications Matrix Specification Component Factory Standard Parameter Light to medium-weight woven and knit textiles Max Sewing Speed 5,000 Stitches Per Minute (SPM) Max Stitch Length 5.0 mm (adjustable via physical dial) Needle System DB×1 or DP×5 (Recommended Sizes: #9 to #18) Presser Foot Lift

: Motor Encoder Connection Fault. The machine head encoder plug at the back of the controller has vibrated loose or collected lint. Disconnect power, unplug the cord, clean the contacts, and firmly re-seat it.

: Toggle between system parameters or scale numbers up and down. Standard Parameter Modifications: Speed Limiting Configuration (Parameter P-01):

If your control panel triggers irregular configurations, press and hold the button while turning the machine's power switch on. zoje a6000-g 02 manual

Wrap the thread around the empty bobbin clockwise several times.

: Recommended systems are DBx1 (sizes 70-110) or 135x5 / 135x5 SERV7 .

With the optional cylinder arm attachment, you can embroider caps. The manual explains how to:

Route thread from the spool stand up through the metal guide arm. Pull down through the pre-tension discs. Turn the screw counterclockwise to increase the oil

Needle is backward; thread path is incorrect; tension is too tight.

[ Thread Stand Assembly ] │ ▼ [ Machine Head Mounting ] ──► (Secure Oil Pan Rubber Cushions) │ ▼ [ Lubrication Fluid Intake ] ──► (Fill between HIGH and LOW lines) │ ▼ [ Needle & Thread Path Routing ] 1. Machine Head Stand Integration

Check the control panel for error codes; ensure the plug is secure.

Guide the thread up and through the hole of the needle take-up lever from right to left. : Toggle between system parameters or scale numbers

Push the latch lever forward against the bobbin to engage the gear mechanism.

Pass the thread from the spool stand up through the thread guide. Bring the thread down to the top thread tension assembly. Guide it through the upper thread guide plate. Thread through the tension discs, moving clockwise.

Remove the needle plate and clear away packed lint, dust, and fiber remnants from around the feed dogs using a soft brush.