Fix: Chipblaster Jv10 Manual

Connect the unit to the correct factory voltage (typically 230V or 460V three-phase AC) as specified on the unit’s serial plate. Check pump rotation immediately after wiring.

The unit utilizes high-capacity dual bag or cartridge filters. Replace the filters immediately when the differential pressure gauge indicates a clog or when the control panel displays a flow alarm. Clean the side tank cleanouts periodically to prevent fine sludge buildup. Scheduled Oil Changes

Control Panel: The control panel typically features an ON/OFF switch, a pressure gauge, and indicator lights for various system statuses. chipblaster jv10 manual

Water-soluble oils, semi-synthetics, synthetics, and straight oils.

Correct initial plumbing and electrical setup ensures that the system interfaces properly with the host CNC machine. Plumbing Connections Connect the unit to the correct factory voltage

Wire the emergency stop (E-stop) loop and fault signals back to the CNC control to shut down the machine if the pump loses pressure. 3. Operating Instructions Priming the Pump

What are you currently experiencing?

Inspect hoses, fittings, and electrical enclosures for leaks or loose wires.

Pleated filter cartridges trap particulate matter down to 10 microns. A crossover valve setup allows operators to swap clogged filters while the unit remains fully operational. a pressure gauge

Run the high-pressure braided hose from the JV10 outlet to the high-pressure manifold or directly to the machine tool spindle interface. Electrical Connections