Xycd60 Manual -

The XY-CD60 is a multi-functional battery controller designed to automate the charging and discharging cycles of DC batteries. Supporting a wide voltage range (6V to 60V), it acts as a safeguard against overcharging and deep discharging, which are critical factors in extending battery lifespan. 2. Technical Specifications Voltage Range: DC 6V–60V. Control Accuracy: Output Type: Direct output (Relay switch). Voltage Error: plus or minus 0.1 cap V Primary Modes: Charging Control (P-1): Activates when battery voltage drops below a lower limit. Discharging Control (P-2): Activates when battery voltage exceeds an upper limit. 3. Operating Modes and Logic

A: No, it cannot. The XY-CD60 is a simple voltage controller and a switch, not a voltage regulator. It turns the output on and off based on pre-set voltage thresholds but does not alter the voltage itself. xycd60 manual

(often labeled XY-CD60L or similar variants) , offering detailed instructions on setup, operating modes, and configuration. 1. Features and Technical Specifications Technical Specifications Voltage Range: DC 6V–60V

Approx 64 x 40 x 19mm (Dimensions may vary slightly by variant). 2. Wiring and Installation Guide it is suitable for Lithium (3S-14S)

No. The XY‑CD60 is a voltage‑controlled switch only. For a solar charge controller, you need a dedicated charge controller with MPPT or PWM functionality to regulate charging current and prevent panel over‑voltage.

A: Yes, it is suitable for Lithium (3S-14S), Lead-Acid, and Lifepo4, provided the voltage is between 6V-60V ElectronicsComp.