Align the bracket on the search coil with the plastic clevis at the bottom of the lower stem. Insert the plastic connector bolt, place the washers, and tighten the wing nut by hand. Do not overtighten.
Turn the knob halfway up. Wave the nail again; the audio should be silent or produce a broken sputter. Wave the quarter; it should still beep cleanly. Step 2: Proper Sweeping Technique
| Control Label | Function | | :--- | :--- | | | Adjusts the detection depth and signal amplification. Higher settings can detect deeper targets but may increase false signals in mineralized ground. | | DISC (DISCRIMINATION) | Rejects unwanted metals (like iron or pull-tabs) so the detector only beeps on more valuable targets like silver or copper. | | VOLUME | Controls the loudness of the loudspeaker or connected headphones. Recommended initial setting is 10. | | RESET | A small button that instantly retunes the detector to the current ground conditions, eliminating false signals caused by mineralized soil or environmental noise. | | THRESHOLD | Sets the background hum or "leading signal" of the detector. Adjust it so it's either a faint whisper or just below the level of hearing. | | GROUND | (Some models) Manual fine-tuning of the detector's response to different soil conditions. Adjustable from -5 to +5, with "0" being typical. |
If no ground balance knob – it’s preset. Lift coil 30cm → slight tone change is normal. Orbitor Prospector 100 Metal Detector Manual
Orbitor Prospector 100 Metal Detector Manual: Owners Guide & Field Instructions
These are just some of the features that may be included in the Orbitor Prospector 100 Metal Detector Manual. The actual features may vary depending on the device and its intended use.
This visual needle moves to the right when a target is detected. Align the bracket on the search coil with
Before your first hunt, proper assembly is crucial for comfort and performance.
The Orbitor Prospector 100 Metal Detector Go to product viewer dialog for this item.
Loosen the shaft length adjustment lock. Insert the lower shaft into the upper shaft. Adjust to a length that allows the search coil to rest approximately 1–2 inches (2–5 cm) off the ground when you stand upright holding the detector. Turn the knob halfway up
The Orbitor Prospector 100 Metal Detector Manual is an essential resource that provides users with a comprehensive guide to operating and maintaining their device. The manual covers various aspects of the metal detector, including:
Controls how deep the detector searches. High sensitivity detects deeper objects but can cause erratic chatter in mineralized soil or near power lines.
Are you missing a specific or installation detail? Share public link