Press the spring-loaded lever and gently but swiftly pull the filament completely out of the assembly to prevent it from hardening and snapping inside the thermal tube. 5. Software and Slicing Configuration
The leveling procedure is as follows:
Slice the model and save the gcode file to the USB drive. 5. Printing and Monitoring Insert USB: Insert the USB drive with your sliced file.
: Clean the PEI build plate with dish soap and water or Isopropyl Alcohol (IPA) to remove finger oils .
Remove the upper foam padding containing the accessory box, power cable, and filament spools. qidi x-pro manual
Tighten or loosen the plastic wing nut directly underneath that corner until you feel a slight friction/resistance when pulling the paper.
The X-Pro relies on a manual three-point leveling system. Perfect bed leveling is the single most critical factor for achieving proper first-layer adhesion. [Back Center Knob] O O O [Front Left] [Front Right] The Leveling Process
The QIDI X-Pro arrives mostly assembled. Follow these steps to clear shipping restraints safely:
Are you planning to use for a multi-color print, or are you just getting started with basic PLA printing ? I can give you specific settings for either. Makerspace - Chalon M3LAB: 3D Printing Stations Press the spring-loaded lever and gently but swiftly
Some reviewers point out that the extrusion unit requires manual installation, which might be intimidating for absolute novices but is clearly documented in the user guide. Maintenance:
Precise bed leveling is the most critical factor for successful 3D prints. The QIDI X-Pro utilizes a manual, assisted 3-point leveling system. Step-by-Step Assisted Leveling On the touchscreen, navigate to > Leveling .
This indicates a partial clog or a temperature that is too low. Increase the nozzle temperature by 5–10°C or use the included cleaning needle to clear debris from the nozzle tip while hot. Issue 3: Prints do not stick to the bed
If printing a dual-color or multi-material model, select each part of the split STL model and assign them to their respective extruders. Remove the upper foam padding containing the accessory
On the touchscreen, choose Print > USB > Select File.
Place the dual-extruder head onto the X-axis carriage guide pins. Secure it from underneath using the provided hex screws. Connect the main ribbon cable to the top of the print head.
If Wi-Fi printing fails, ensure your computer and the printer are connected to the exact same 2.4GHz network band, as the printer does not support 5GHz networks.
) directly from the print interface while the first layer is being laid down . 🧼 Maintenance & Troubleshooting