Gilbarco Sk700 Programming Manual 2021 Jun 2026

Programming is performed using the located inside the dispenser’s head unit. Press the F1 key to initiate the command entry.

According to the manual, this is a . Perform a "Hard Program Reset":

Advanced settings for pump hydraulics and meter mapping. Gilbarco Sk700 Programming Manual

The dispenser has lost contact with the indoor forecourt controller or POS system.

While the official manual spans 80+ pages, the following are the most common programming sequences every user should know. Programming is performed using the located inside the

Remove the cover over the CPU PCB to access the configuration switches and jumpers.

The dispenser has lost contact with the POS forecourt controller. Inspect the 2-wire/current loop wiring loop and distribution box. 5. Mechanical & Electronic Calibration (Weights & Measures) Perform a "Hard Program Reset": Advanced settings for

| Error Code | Meaning / Possible Cause | Troubleshooting Step | | :--- | :--- | :--- | | | Configuration Error : Data mismatch between the central processor and the E-Cal board. The configuration in memory does not match. | Perform a "Warm Start" (F1, F2). If the issue persists, a "Cold Start" (full reset and configuration restoration) may be necessary. | | E7 | ECAL Board Memory Error : Fault with the E-Cal board's memory, possibly indicating a hardware failure. | Attempt a reset. If the error returns, the E-Cal board or display board may need replacement. | | Pump runs slow / erratic | Clogged Filter : Hydraulic resistance causes pressure to drop. | Replace the fuel filter per your maintenance schedule. | | Display flickers / inaccurate | Communication Error : Loose connectors, burnt contacts, or faulty connections between control boards. | Inspect all connections and wiring harnesses. Reseat any loose connectors and check for physical damage. |